Keer electro-optic measurements in liquid dielectrics
Author(s)
Zhang, Xuewei![Thumbnail](/bitstream/handle/1721.1/91035/892914936-MIT.pdf.jpg?sequence=5&isAllowed=y)
DownloadFull printable version (6.719Mb)
Other Contributors
Massachusetts Institute of Technology. Department of Electrical Engineering and Computer Science.
Advisor
Markus Zahn.
Terms of use
Metadata
Show full item recordAbstract
Kerr electro-optic technique has been used to measure the electric field distribution in high voltage stressed dielectric liquids, where the difference between refractive indices for light polarized parallel and perpendicular to the local electric field is a function of the electric field intensity. For transformer oil, the most widely-used insulating liquids in power apparatus and high voltage technology, Kerr effect is very weak due to its low Kerr constant. Previous Kerr measurements have been using ac modulation technique, which is only applicable to dc steady-state electric field mapping while various instabilities develop in liquid under long-term high voltage application. The use of the high-sensitivity CCD camera as optical detector makes it possible to capture the weak Kerr effect in high voltage stressed transformer oil. The first part of this thesis is to demonstrate the reliability and evaluate the sensitivity of the measurements for various cases with identical electrodes under pulsed excitation with insignificant flow effects. After the validation and optimization of the experimental setup, measurements are taken to record the time evolution of electric field distributions in transformer oil stressed by high voltage pulses, from which the dynamics of space charge development can be obtained. Correlation between space charge distribution pattern and impulse breakdown voltage is examined. Hypothetically, bipolar homo-charge injection with reduced electric field at both electrodes may allow higher voltage operation without insulation failure, since electrical breakdown usually initiates at the electrode-dielectric interfaces. It is shown that the hypothesis is testable and correct only under specific circumstances. Besides, fractal-like kinetics for electrode charge injection is identified from the measurement data, which enriches the knowledge on ionic conduction in liquids by offering an experimentally-determined boundary condition to the numerical model. Physical mechanisms based on formative steps of adsorption-reaction-desorption reveal possible connections between geometrical characteristics of electrode surfaces and fractal-like kinetics of charge injection. The second part of this thesis focuses on the fluctuations in the detected light intensity in Kerr measurements. Up to now, within an experimentally-determined valid range of high voltage pulse duration, the strategy to reduce fluctuation has been taking multiple measurements and then averaging the results. For very short impulses, it is found that the light intensities near the rough surfaces of electrodes both fluctuate in repeated measurements and vary spatially in a single measurement. The major cause is electrostriction which brings disturbances into optical detection. The calculated spatial variation has a strong nonlinear dependence on the applied voltage, which generates a precursory indicator of the electrical breakdown initiation. This result may have potential applications in non-destructive breakdown test and inclusion detection in dielectric liquids. When the applied voltage is dc or ac, signatures of turbulent electroconvection in transformer oil are identified from the Kerr measurement data. It is found that when the applied dc voltage is high enough, compared with the results in the absence of high voltage, the optical scintillation index and image entropy exhibit substantial enhancement and reduction respectively, which are interpreted as temporal and spatial signatures of turbulence. Under low-frequency ac high voltages, spectral and correlation analyses also indicate that there exist interacting flow and charge processes in the gap. This also clarifies the meaning of dc steady state and the requirement on ac modulation frequency in Kerr measurements.
Description
Thesis: Ph. D., Massachusetts Institute of Technology, Department of Electrical Engineering and Computer Science, 2014. This electronic version was submitted by the student author. The certified thesis is available in the Institute Archives and Special Collections. Cataloged from student-submitted PDF version of thesis. Includes bibliographical references.
Date issued
2014Department
Massachusetts Institute of Technology. Department of Electrical Engineering and Computer SciencePublisher
Massachusetts Institute of Technology
Keywords
Electrical Engineering and Computer Science.